IPACCESS-CONFIG

NAME

ipaccess-config - Tool to configure an ip.access nanoBTS

SYNOPSIS

ipaccess-config [options] <IP_OF_BTS>

DESCRIPTION

ipaccess-config is a small command line tool to configure an ip.access nanoBTS.

You can use this tool to perform basic operations such as setting NVRAM parameters or performing tests.

It is part of the OpenBSC base station controller from Osmocom.

OPTIONS

Commands for writing to the BTS:

-u --unit-id UNIT_ID

Set the Unit ID of the BTS

-o --oml-ip IP

Set primary OML IP (IP of your BSC)

-i --ip-address IP/MASK

Set static IP address + netmask of BTS

-g --ip-gateway IP

Set static IP gateway of BTS

-r --restart

Restart the BTS (after other operations)

-n --nvram-flags FLAGS/MASK

Set NVRAM attributes

-S --nvattr-set FLAG

Set one additional NVRAM attribute

-U --nvattr-unset FLAG

Set one additional NVRAM attribute

-l --listen TESTNR

Perform specified test number

-L --Listen TEST_NAME

Perform specified test

-s --stream-id ID

Set the IPA Stream Identifier for OML

-d --software FIRMWARE

Download firmware into BTS

Miscellaneous commands:

-h --help

this text

-H --HELP

Print parameter details.

-f --firmware FIRMWARE

Provide firmware information

-w --write-firmware

This will dump the firmware parts to the filesystem. Use with -f.

-p --loop

Loop the tests executed with the --listen command.

SEE ALSO

ipaccess-find(1)

AUTHOR

This manual page was written by Ruben Undheim <ruben.undheim@gmail.com> for the Debian project (and may be used by others).